Introduction to COOL PI CM5 interface

george

Top-level interface

The 2X20 pin interface is compatible with CP4 and integrates multiple UART, I2C, SPI, CAN and other functions.
Three function keys are PWR, RST and LOADER.
2X2 PIN POE connector，such as CP4.
30pin fpc vertical connector can directly drive standard 30PIN EDP interface LCD. Resolution up to 3840 * 2160
The MICRO HDMI-RX interface can support up to 4KP60 video signal input.
TF card with self-locking.
Two native USB3.0 interfaces, one of which supports OTG function.
Two Gigabit Ethernet interfaces, one of which supports POE function.
Two HDMI2.1 interfaces with a maximum resolution of 8K.
Stereo headphone stand with MIC input function.
Two native USB2.0 interfaces.
One TYPEC power supply interface, consistent with CP4.
The external power interface of 2PIN can support DC power input.
1 standard PCIE 4X connector, currently only supports PCIE3.0 2X/1X mode.
SSD interface, only PCIE-M2-2242 size hard disk is supported.
Standard 7PIN SATA3.0 interface, 4PIN power interface.
M.2 WIFI module interface, supporting multiple general WIFI modules.
Dual MIPI LCD interfaces support simultaneous output of two MIPI interface LCDs. The resolution of a single LCD is up to 1920 * 1200. It supports the MIPI DSC function.
Four independent MIPI camera interfaces support four camera inputs at the same time. It can be configured as 2X4LINE or 4X2LINE mode.

Twsuts

@george 您好，请问一下底板资料啥时候出来

顾真牛

@george 不错不错

顾真牛

@george 就是俩usb3 是不是稍微少了点呀板子上留几个usb的接线口也行呀

顾真牛

@george 哦还有俩usb2的应该够用了，

george

@Twsuts 底板已经在制版中。预计月底可以出来。

george

@顾真牛有标准PCIE接口，USB3.0不够可以扩展。外置4个USB接口，2个U2 两个U3。一般场景可以满足。

george

@Twsuts 正常需要初步验证和测试完成以后，底板资料才可以开放。目前核心板已经是稳定版本。

顾真牛

@george 已经拿到板子在测试验证了吧放些图吧

george

@顾真牛这个还没有贴片回来，拿到后会第一时间反馈。